Sample Exam – NICET Fire Alarm Level I

Consider the use of visible notification appliances. Wall mounted appliances shall be mounted such that the entire lens is not more than _____ inches above the finished floor?

Fixed temperature, nonrestorable spot type heat detectors shall be replaced _____ years from initial installation, or have 2 detectors per 100 laboratory tested?

Which of the following is not required to be delivered to the owner upon final acceptance of the system? (Select Two)

Consider the secondary power supply for a fire alarm system. The secondary power supply shall have sufficient capacity to operate the system under quiescent load for a minimum of _____?

The location of the branch circuit over current protective device shall be permanently identified at the fire alarm control unit. Which of the following is a requirement of the circuit disconnecting means? (Select Three)

PLFA cables shall have a voltage rating of not less than _____ volts?

What is the inspection frequency for a waterflow device?

Consider a 24 volt circuit with 3 resistors in series where R1 and R2 = 10 ohms each, and R3 = 4 ohms. The voltage measured across R1 = 10 volts. The voltage measured across R2 = 10 volts. The voltage measured across R3 = _____ volts?

Under what circumstances is it appropriate to use a tourniquet? (Select Two)

Extension ladders shall be erected with the base of the ladder _____ of the length of the ladder from the wall.